Installation: 
 1.) Carefully remove all the fittings from the box
 2.) Find a suitable location for the Solar Step Lights, on a wall, step or stairs...
 3.) Measure the width of two holes on the back of the Solar Step Lights to align holes for 2 the screws on the surface.
 4.) If mounting on masonry, brick, or cement, use a drill for the holes insert wall plugs and fixing screws. Insert the wall plugs supplied so they are flush with the surface. Insert the screws and leave at least 6mm, or 5mm of the screws outside of the surface for holding the Solar Step Lights.
 5.) Mount the Solar Step Light on the screws by placing the unit over the holes.

Replacing the Battery :
 1) Release the screws on the back of the unit and slide out the back cover part. 
 2) Remove the old battery. Make sure the new battery is high quality Ni-Mh AAA rechargeable battery. 
 3) Install the new battery in to the battery compartment, ensuring the correct polarity is observed. 
 Reassemble the unit by replacing the back cover. For best results Ni-Mh battery should be replaced every 12 months. 
 
 Trouble Shooting: 
 If your Solar Step Light does not come on at dusk despite observance of all the instructions, please try the following steps: 
 1) Make sure the Solar Step Light is not being affected by any other light source, if this is the case move your Solar Step Light to a location where there is less light interference. 
 2) Make sure the Solar Step Light’s solar panel is not located in the shade during the day. 
 3) Make sure the switch is in the AUTO position. 
 4) Check that battery is installed correctly.